The previous post on phase noise discussed about finding the root mean square phase noise for a given phase noise profile. In this post let us discuss about the impact of phase noise on the error vector magnitude (evm) of a transmit symbol.
Following a brief discussion with my friend Mr. Rethnakaran Pulikkoonattu on phase noise profiles, he pointed me to his write up on Oscillator Phase Noise and Sampling Clock Jitter . In this post, we will discuss the math behind integrating the phase noise power spectral density (in dBc/Hz) to find the root mean square jitter value.
Oscillators are used in typical radio circuits to drive the mixer used for the up-conversion or down-conversion of the passband transmission. Ideally, the spectrum of the oscillator is expected to have an impulse at the frequency of oscillation with no frequency components else where. However the spectrum of practical oscillators do have spectrum skirts around…
This post discuss about the thermal noise in RC low pass filter. Using the noise equivalent model using resistor with a voltage source, which gets passed through a no noise RC low pass filter. The noise power at the output is computed by integrating the output voltage spectral density over all frequencies.
Following the discussion on thermal noise and it’s modeling and noise figure computation for a simple resistor network, in this article let us discuss the Noise Figure of cascaded stages.
The post on thermal noise described the noise produced by resistor ohms over bandwidth at temperature Kelvin. In this post, let us define the noise voltage at the input and output of a resistor network and further use it to define the Noise Figure of such a network.
SOLVED the Rubik’s cube !!! After 6 months, 2 cube’s and countless twists and turns, extremely glad to reach here. Will enjoy the beauty of the solved cube for couple of days before breaking it and going over the whole journey again…. (Thanks dear Kunju for introducing me to the cube) Disclosure : After solving…
A friend called me up couple of days back with the question – How white is AWGN? I gave him an answer over phone, which he was not too happy about. That got me thinking bit more on the topic and the result is this post – brief write up on thermal noise and it’s…
An earlier post we discussed hard decision decoding for a Hamming (7,4) code and simulated the the bit error rate. In this post, let us focus on the soft decision decoding for the Hamming (7,4) code, and quantify the bounds in the performance gain.
My friend and colleague Mr. Vineet Srivastava pointed me to a nice article on clock jitter – Clock Jitter Effects on Sampling : A tutorial – by Carlos Azeredo-Leme, IEEE Circuits and Systems Magazine, Third Quarter 2011. In this post, let us discuss the total Signal to Noise Ratio at the output of an analog to…
From the post on Closed Form Solution for Linear regression, we computed the parameter vector which minimizes the square of the error between the predicted value and the actual output for all values in the training set. In that model all the values in the training set is given equal importance. Let us consider the case where it is known…
From the previous posts on Linear Regression (using Batch Gradient descent, Stochastic Gradient Descent, Closed form solution), we discussed couple of different ways to estimate the parameter vector in the least square error sense for the given training set. However, how does the least square error criterion work when the training set is corrupted by…
In May 2008, we derived the theoretical symbol error rate for a general M-QAM modulation (in Embedded.com, DSPDesignLine.com and dsplog.com) under Additive White Gaussian Noise. While re-reading that post, felt that the article is nice and warrants a re-run, using OFDM as the underlying physical layer. This post discuss the derivation of symbol error rate for a general…
Some of us would have used Newton’s method (also known as Newton-Raphson method) in some form or other. The method has quite a bit of history, starting with the Babylonian way of finding the square root and later over centuries reaching the present recursive way of finding the solution. In this post, we will describe…