Articles

## GATE-2012 ECE Q16 (electromagnetics)

Question 16 on electromagnetics from GATE (Graduate Aptitude Test in Engineering) 2012 Electronics and Communication Engineering paper. Q16. A coaxial cable with an inner diameter of 1mm and outer diameter of 2.4mm is filled with a dielectric of relative permittivity 10.89. Given ,  the characteristic impedance of the cable is (A)  (B)  (C)  (D)  Solution To…

## GATE-2012 ECE Q39 (communication)

Question 39 on communication from GATE (Graduate Aptitude Test in Engineering) 2012 Electronics and Communication Engineering paper. Q39. The signal  as shown is applied both to  a phase modulator (with  as the phase constant) and a frequency modulator (with as the frequency constant) having the same carrier frequency.  The ratio  for the same maximum phase deviation is,…

## GATE-2012 ECE Q47 (math)

Question 47 on math from GATE (Graduate Aptitude Test in Engineering) 2012 Electronics and Communication Engineering paper. Q47. Given that and , the value of is (A)  (B)  (C)  (D)  Solution To answer this question, we need to refer to Cayley Hamilton Theorem. This is discussed briefly in Pages 310-311 of Introduction to Linear Algebra, Glibert Strang (buy…

## Update : Correction to solution of GATE-2012 ECE Q38

Thanks to Mr. Raghava G D’s comments on the post discussing Question 38 on Communication from GATE (Graduate Aptitude Test in Engineering) 2012 Electronics and Communication Engineering paper, realized that I had made an error in the solution. Have the updated the post with the right answer and additional explanations.

## GATE-2012 ECE Q38 (communication)

Question 38 on Communication from GATE (Graduate Aptitude Test in Engineering) 2012 Electronics and Communication Engineering paper. Q38. A binary symmetric channel (BSC) has a transition probability of 1/8. If the binary transmit symbol X is such that P(X=0)=9/10, then the probability of error for an optimum receiver will be (A) 7/80 (B) 63/80 (C)…

## GATE-2012 ECE Q3 (communication)

Question 3 on Communication from GATE (Graduate Aptitude Test in Engineering) 2012 Electronics and Communication Engineering paper. Q3. In a baseband communications link, frequencies upto 3500Hz are used for signalling. Using a raised cosine pulse with 75% excess bandwidth and for no inter-symbol interference, the maximum possible signaling rate in symbols per second is, (A)…